Manual

Figure 21 -/nsta//Siphoning Tube
NOTE:
Makesurethe filter remainsfully submergedin detergent
while applying detergent.
NOTE:
Contactwith the hotmuffler candamagedetergentsiphoning
tube.
.
• Wheninsertingthesiphonintoadetergentsolutionbottle,routethe
tubeso asto keepit frominadvertentlycontactingthe hotmuffler.
Makesure blackdetergentnozzleis installed.
NOTE:
Detergent cannotbe appliedwiththehighpressurenozzle
(Yellow,White,Greenor Bed). Only use the Black nozzlewith
detergent.
8. Confirm set-up instructions have beenfollowed.
NOTE:
Youmustattachall hosesbefore youstartthe engine.
= Startingtheenginewithoutallthehosesconnectedandwithoutthe
waterturnedONwill damagethe pump.
• Damageto equipmentresultingfromfailureto followthisinstruction
willvoidwarranty.
9. Start enginefollowing instructions How to Start Your Power
Washer.
10. Apply detergentto a dry surface, starting at lower portion
of area to be washed and work upward using long, even,
overlappingstrokes.
11. Allow detergentto "soak in" for 3-5 minutes before washing
and rinsing. Reapply as needed to prevent surface from
drying. DO NOT allow detergent to dry on surface being
cleaned(preventsstreaking).
IMPORTANT:Youmust flush the detergentsiphoningsystem after
each use by placing the filter into a bucket of cleanwater,then run
the powerwasher in low pressurefor 1-2 minutes.
POWERWASHERR/NS/NG
1. Removeblackdetergentnozzlefrom lance.
2. Select and install desired high pressure nozzle following
instructions Howto UseNozzles.
3. Point spray gun in safe direction and away from people,
animals and plants. Squeezetrigger to flush any remaining
chemical from system.
4. Keepspraygun a safe distancefrom areayou planto spray.
"_ Im_,_ Kickback fromspraygun can causeyouto fall.• Useonlyona levelsurface.
• Donot useonelevatedsurfaceto preventthe risk
of a seriousfall.
• Beextremelycarefulif you must usethe powerwasherfrom a
ladder,scaffolding,or anyothersimilarlocation.
• Firmlygraspspraygunwithbothhandswhenusinghighpressure
sprayto avoidinjurywhenspraygunkicksback.
5. Apply a high pressurespray to a small area andthen check
surface for damage.If no damageis found, you can assume
it is okay to continuerinsing.
6. Start at top of areato be rinsed, working down with same
overlappingstrokesas you usedfor cleaning.
CLEANINGDETERGENTSIPHONINGTUBE
If you used the detergentsiphoning tube, you must flush it with
clean water beforestoppingthe engine.
1. Place detergentsiphoning tube/filter in a bucket full of clean
water.
2. Removehigh pressurenozzlefrom nozzleextension.
3. Selectandinstall blackdetergentnozzlefollowing instructions
How to Use Nozzles.
4. Flushfor 1-2 minutes.
5. Shut off engine following instructions How to Stop Power
Washerand turn off water supply.
6. ALWAYSpoint spray gun in a safe direction, squeezespray
gun trigger to release retained high water pressure. Engage
trigger lock when not in use.
IMPORTANT: Spray gun traps high water pressure, even when
engineis stoppedandwater is disconnected.
The highpressurestreamof waterthat this equipment
producescancutthroughskinand its underlying
tissues,leadingto seriousinjury and possible
amputation.Spray guntrapshighwater pressure,even
whenengine isstoppedand water is disconnected,
whichcancauseinjury.
• Keephighpressurehoseconnectedto pumpandspraygunwhile
systemis pressurized.
• ALWAYSpointspraygun in safe direction,andsqueezespray
guntriggerto releasehighpressure,everytimeyou stopengine.
Engagetriggerlockwhennotin use.
11