Manual

CONNECTHOSEANDWATERSUPPLYTOPUMP
NOTE:
DONOTrunthe pumpwithoutthe watersupplyconnected
andturnedon. Damageto equipmentresultingfrom failureto
followthisinstructionwill voidwarranty.
NOTE:
Removeand discardthe shippingcapfrom the pump'swater
inletbefore attachinghose.
1. Runwater through your gardenhose for 30 seconds to clean
out any debris.
2. Before connecting garden hose to water inlet, inspect inlet
screen (A) (Figure 8). Clean screen if it contains debris or
haveit replacedif damaged.DONOTrun power washerif inlet
screenis damaged.
IMPORTANT:DONOTsiphon standingwaterfor the watersupply.
Use ONLYcold water (less than 100°F). Water supply must be
adequateto handlegreaterthan 3.8 gallons perminuteandno less
than 30 psi.
NOTE:
Using a OneWayValve (vacuum breaker or checkvalve)at
pumpinletcancausepumpor inletconnectordamage.
• There MUST be at least ten feet of unrestricted garden hose
betweenthe power washer inlet and any device, such as a
vacuum breakeror check valve.
• Damage to equipment resulting from failure to follow this
instructionwill void warranty.
Figure 8 - Inspect Inlet Screen
Figure9 - ConnectGardenHose
Risk of eye injury.Spray can splashback or propel
..>d_ objects.
.
• Always wear safety goggles when using this equipment or in
vicinity of equipment in use.
• Before starting the power washer, be sure you are wearing
adequatesafety goggles.
• NEVERsubstitutesafety glassesfor safety goggles.
Connect lance to spray gun (Figure 10). Tighten by hand.
Figure10 - Attach Lance
3. Connectthe gardenhose (not to exceed50 feet in length)to
the water inlet (Figure9). Tightenby hand.
.
/
Attach endof high pressurehoseto baseof spray gun (Figure
11). Tightenby hand.
figure11 - ConnectHose toSprayGun