Install Manual

Installing Generac PWRcell Battery

18 Installation Manual for Generac PWRcell Battery

Installing Module Spacer (PWRcell 9 and

PWRcell 15 only)

See Figure 4-11. Module spacers (O) must be installed

on any single module shelf.

009933

Figure 4-11. Module Spacer

PWRcell modules and upgrade kits can be obtained by

contacting Generac Customer Service at 1-888-436-

3722 (1-888-GENERAC), or www.generac.com.

NOTE: Kits must be installed by a qualified individual.

Table 5 – Module Spacer Kit

Module Spacer Kit Part Number

Generac PWRcell Spacer Kit APKE00008

To install module spacer:

1. See Figure 4-12. Angle top of spacer (P) under

and behind bracket lip (Q).

009934

Figure 4-12. Installing Module Spacer (1 of 3)

2. See

Figure 4-13

. Slide spacer up between brackets.

3. Push bottom of spacer in.

009935

Figure 4-13. Installing Module Spacer (2 of 3)

4. See Figure 4-14. Secure spacer with two M4X8

SEMS screws and torque to 13 in-lb (1.47 Nm).

009936

Figure 4-14. Installing Module Spacer (3 of 3)

Installing Retention Clips

See Figure 4-15. All front battery modules must be

secured with retention clips (R).

009937

Figure 4-15. Retention Clips (1 of 3)