Mobile Link - Quick Start

Mobile Link Wi-Fi/Ethernet Device Installation
2. Identify the two battery wires from the Mobile Link
device harness with the ring terminals located in
the engine compartment.
NOTE: Mob
ile Link device harness power wires consist
of a black negative (-) power wire and a fused red posi-
tive (+) power wire.
3. See Figure 2. Loosen and remove nuts (A) from
positive (+) battery terminal and negative (-) battery
te
rminal screws on the battery cables. Slide har-
ness power wires (B) over battery terminal screws
an
d replace nuts. Tighten securely.
004942
B
A
Figure 2. Attach Harness Power Wires
4. Use tie
wrap to bundle excess power wire length, if
necessary.
5. Con
nect positive (+) battery cable first, then nega-
tive (-) battery cable.
Device Setup / Connecting to Wi-Fi Network
See Mobile Link installation and user manual for instruc-
tions on setting up device and connecting to Wi-Fi net-
work. Proceed to Installing Ethernet Cable (If
Required) if Ethernet cable is required.
Installing Ethernet Cable (If Required)
Proceed as follows to install Ethernet cable:
1. See Figure 3. Unit may have a knockout (C) on
rear kick plate at unit base (either side). Run Ether-
net cable through knockout in kick plate or pull
cabl
e through generator installation pad.
010764
C
E
D
Figure 3. Ethernet Cable Install Locations
2. Pull
cable through hole in support rail (D), or
through cutout in stub-up area (E) and route
upward to plug into device.
3. Use
tie wraps to secure Ethernet cable away from
any high voltage wires or connections.
Activation
See Registration and Mobile Link Cellular App sections in
Mobile Link installation and user manual.
Part No. A0000479091 Rev A 04/29/2020
©2020 Generac Power Systems, Inc.
All rights reserved.
Specifications are subject to change without notice.
No reproduction allowed in any form without prior written consent from
Generac Power Systems, Inc.
Generac Power Systems, Inc.
S45 W29290 Hwy. 59
Waukesha, WI 53189
1-888-GENERAC (1-888-436-3722)
www.generac.com