Product Manual
Table Of Contents
- Section 1: Safety Rules & General Information
- Section 2: General Information
- Section 3: Activation and Startup
- Section 4: Operation
- Section 5: Maintenance
- Component Locations
- Access Panels
- Maintenance
- Remove From Service
- 25 Hour Break-In
- Daily Maintenance
- Schedule A Maintenance
- Schedule A Maintenance Item Locations
- Preliminary Instructions
- Inspecting the Enclosure Louvers
- Inspecting the Fuel Lines
- Inspecting Coolant Level and Hoses
- Inspecting Radiator for Clogging
- Checking Lubricating Oil Level and Drain Hose
- Replacing Lubricating Oil and Oil Filter
- Checking Battery Condition/Fluid Level
- Inspecting Accessory/Drive Belt
- Replacing Air Filter Element
- Final Instructions
- Schedule B Maintenance
- Schedule C Maintenance
- Return To Service
- Section 6: Troubleshooting
Operation
18 Owner’s Manual for Spark-Ignited Stationary Generators
AUTO/MANUAL/OFF
Menu Navigation
See Figure 4-2.
Feature Description
AUTO
Activates fully automatic operation. Green LED illuminates to verify system is in AUTO. Transfer to standby
power occurs if utility power fails. Functionality of exercise timer is enabled, if set.
MANUAL
Cranks and starts engine. Blue LED illuminates to verify system is in MANUAL. Transfer to standby power
occurs if utility power fails. Functionality of exercise timer is disabled.
OFF
Shuts down engine, if running. Red LED illuminates to verify system is in OFF. Transfer to standby power
does not occur if utility power fails.
Feature Description
System Menus
HOME Screen
System returns to Home screen if control panel is not used for five minutes. Screen normally displays a sta-
tus message, such as Ready to Run (AUTO) or Switched to OFF (OFF), and total Hours of Protection. If an
active alarm/warning condition occurs, the associated Alarm/Warning message is displayed. To clear
Alarm/Warning message, press OFF on control panel, followed by ENTER. In the event of multiple Alarms/
Warnings, next message is then displayed. The highest priority alarm is always displayed first.
Display Backlight Normally off. If operator presses any button, backlight will automatically light and remain on for 30 seconds.
MAIN MENU
Allows operator to navigate software using up arrow, down arrow, ENTER, and ESCAPE. MAIN MENU can
be accessed from any sub menu by consecutively pressing ESCAPE. Each time ESCAPE is pressed, the
preceding menu is displayed. MAIN MENU is reached when System, Date/Time, Battery, and Sub-Menus
are displayed.
SUB-MENUS Sub-Menus screen includes HISTORY, MAINT, EDIT, and DEALER menus.
HISTORY
HISTORY screen includes an alarm log and run log. Alarm log displays the last 50 alarm events. Run log
displays the last 50 operational events.
MAINTENANCE
MENU
Includes Run Hours, Maintenance Log, and Schedule. Run Hours displays cumulative hours on engine.
Maintenance Log displays the last service warnings and service completions. Schedule displays when the
next scheduled maintenance interval warning will occur.
EDIT MENU
Includes Language, Current Date/Time, Exercise Settings, Firmware Update, Startup Delay, and Warm up
Time. All of these settings are adjustable without a password.
DEALER MENU Includes password protected settings and can be adjusted by an IASD during installation or a service visit.
Navigation
ESCAPE Used to abort a routine or return to the preceding menu.
ENTER Used to make a selection or save an entry.
UP ARROW
DOWN ARROW
Used to move forward or backward from menu to menu, or to scroll forward or backward (increment or dec-
rement) through available selections.
NOTE: Pressing the control panel illuminates the backlight for 30 seconds. The backlight also illuminates for 30 seconds when-
ever an active Alarm/Warning message is displayed.