Product Manual
Maintenance
Owner’s Manual for Stationary Generators 33
Schedule A Maintenance Item Locations
NOTE: The side of the enclosure with the viewing
window is identified as the rear of the generator set. The
right and left sides are identified by standing at the rear
and looking towards the front of the unit.
Model 22/27 kW 25/30 kW 32/38 kW 36/45 kW 48 kW 60 kW
Engine 2.4L 1.5L 2.4L 2.4L 5.4L 2.4L
Coolant Overflow Reservoir
L L L L L L
Oil Dipstick
R R R R L R
Oil Drain Hose
L R L L R L
Oil Filter
R R R R L R
Oil Fill Cap
E E E E R E
Oil Supply Tank Fill Cap
- - - TL - TL
Battery
L R L L R L
Fan Belt
E E E E E E
Air Filter Element
L R L L E L
R = Right Side L = Left Side E = Either Side T = Top - = Not Applicable
Preliminary Instructions
1. See Remove From Service.
2. Re
move left and right side access panels. See
Access Panels.
3. Re
move negative battery cable (black) from
negative (-) battery terminal.
Check Enclosure Louvers
1. Verify that intake and exhaust louvers and open-
ings are clean and unobstructed. Keep clear of
le
aves, grass, snow, and debris.
2. Wipe
exterior surfaces clean using a damp cloth.
3. L
oosen dirt, oil, etc. with a soft bristle brush.
4. Rem
ove loose dirt and debris using a vacuum
cleaner, or low pressure compressed air (not
exceeding 25 psi (172 kPa).
NOTE: Per
iodically wash and wax enclosure using
automotive type products. Frequent washing is
recommended in salt water/coastal areas.
Check Fuel Lines
1. Check fuel lines for leaks. Tighten fittings and
clamps if necessary.
2. Che
ck fuel lines for nicks, dents, kinks, or other
damage. Replace as necessary.
Check Coolant Level and Hoses
(000139)
WARNING
Risk of burns. Allow engine to cool before
draining oil or coolant. Failure to do so could
result in death or serious injury.
1. Verify that the coolant level is between the HOT
and COLD marks on the overflow reservoir. See
Figure 5-6.
NOTE: Co
olant expands when hot, so the level may be
higher than the HOT mark. Do not add coolant higher
than the HOT mark.
2. If
the coolant level is below the COLD mark,
remove fill cap from overflow reservoir and add
coolant. See Coolant Water Treatment.
3. Che
ck coolant hoses for leaks. Tighten hose
clamps, if necessary.
4. Chec
k hoses for nicks, cuts, tears or general
deterioration. Replace as necessary.