Product Manual

WARNING
Explosion. Batteries emit explosive gases.
Always disconnect negative battery cable
first to avoid spark. Failure to do so could
result in death or serious injury.
(000238)
Troubleshooting
50 Owner’s Manual for Stationary Generators
21. Remove battery negative cable (black) from battery
negative (-) terminal.
22. Rem
ove battery positive cable (red) from battery
positive (+) terminal.
23. R
emove two screws to release battery hold-down
clamp from platform.
24. Remove battery
and store in a cool, dry room.
25. Install
left and right side access panels. See
Access Panels.
26. Th
oroughly clean and wipe down the generator.
See Corrosion Protection.
Return From Storage
To return the unit to service after storage, proceed as
follows:
1. Th
oroughly clean and wipe down the generator.
See Corrosion Protection.
2. Re
move left and right side access panels. See
Access Panels.
3. Install ba
ttery onto tray oriented with the negative 
(-) post toward the front of
the enclosure.
4. Install
two screws with nylon washers to secure
battery hold-down clamp to tray.
5. Che
ck battery. See Check Battery Condition/
Fluid Level.
(000133)
WARNING
Explosion. Batteries emit explosive gases.
Always connect positive battery cable first to
avoid spark. Failure to do so could result in
death or serious injury.
6. Install battery positive cable (red) onto battery
positive (+) terminal.
7. Install
battery negative cable (black) onto battery
negative (-) terminal.
8. Chec
k oil level and add oil as necessary. DO NOT
OVERFILL.
NOTE: On 36 kW, 45 kW, and 60 kW models, open
s
hutoff valve to enable Lube Oil Maintainer System.
9. Open
the viewing window. See Open Viewing
Window.
10. Pull
up rubber flap covering fuse holder and install
7.5 amp fuse.
11. Mo
ve the Main Circuit Breaker switch up to the ON
(Closed) position.
12. Pre
ss MANUAL on the control panel to start the
engine. A blue LED illuminates to confirm that the
system is in the MANUAL mode.
13. Allow
the engine to run until it is reaches normal
operating temperature. Check for leaks while the
engine is running.
14. Pre
ss OFF on the control panel. A red LED
illuminates to confirm that the system is in the OFF
mode.
15. Insta
ll left and right side access panels. See
Access Panels.
16. T
urn on utility power to the transfer switch.
17. Pre
ss AUTO on the control panel. A green LED
illuminates to confirm that the system is in the
AUTO mode.
18. Reset th
e time and date.
19. Close the viewing window
.
Attention After Submersion
Do NOT start and operate the generator if it has been
submerged in water. Have an Independent Service
Dealer thoroughly clean, dry, and inspect the generator
following any submersion. If the structure (home) has
been flooded, it should be inspected by a certified
electrician to ensure there won’t be any electrical
problems during generator operation or when utility
power is returned.