Product Manual

Owner’s Manual for Stationary Generators 13
Activation and Startup
Section 3: Activation and Startup
Orientation
NOTE: The 2.4L (32 kW) unit is depicted in the artwork
used in this manual. The location and appearance of
some components may vary between engine models.
The side of the enclosure with the viewing window (A) is
id
entified as the rear of the generator set. The right and
left sides are identified by standing at the rear and
looking towards the front of the unit. The battery is
located on the side of the unit (B).
B
A
009676
Figure 3-1. Enclosure (Rear Left View)
Remove Side Access Panels
NOTE: Access panels are located at both the left and
right sides of the enclosure.
1. Remove k
ey from bag attached to door of unit.
2. In
sert key (B) into latch (A) and rotate
counterclockwise 1/2 turn. See Figure 3-2.
3. Raise pa
nel using thumb latch.
A
B
006370
Figure 3-2. Access Panel Key and Latch (Typical)
Install Battery
(000133)
WARNING
Explosion. Batteries emit explosive gases.
Always connect positive battery cable first to
avoid spark. Failure to do so could result in
death or serious injury.
1. Loosen two screws with nylon washers to release
hold-down clamp from battery tray.
2. See Figure 3-3. Install battery (C) onto tray.
3. Insta
ll two screws with nylon washers to secure
hold-down clamp to battery tray.
4. In
stall positive battery cable (red) (A) to positive (+)
battery terminal.
5. I
nstall negative battery cable (black) (B) to
negative (-) battery terminal.
A
B
C
006372
Figure 3-3. Battery Cable Connections