Use And Care Manual

22 Owner’s Manual for Chipper/Shredder
Maintenance and Troubleshooting
Procedure
Before Each
Use
Every 8
Hours
Every 25
Hours
Every 100
Hours
Check engine oil level 
Inspect general equipment condition 
Verify tire pressure 
Verify shaft turns freely 
Clean engine exterior and cooling fans 
Inspect or replace air filter and foam pre-cleaner 
Inspect knife for damage 
Lubricate side bearings 
Inspect rotor hammers/spacers for wear 
Change engine oil
1
st
time 5 hours

Inspect belt tension and condition
1
st
time 1 hour

Inspect or replace drive belt 
Inspect knife sharpness and wear plate condition 
Check battery voltage (electric start only) 
Inspect or replace spark plug 
Inspect and adjust knife to wear plate gap 
Inspect knife and wear plate attachment screws 
Inspect side bearing collar set screws 