User Manual

November 2, 2010
 Page 5
Certification Number cannot be used on the final product. In these circumstances, the
OEM integrator will be responsible for re-evaluating the end product (including the
transmitter) and obtaining a separate FCC and Industry Canada authorization.
End Product Labeling
The 0H7699 Module is labeled with its own FCC ID and IC Certification Number. If the FCC
ID and IC Certification Number are not visible when the module is installed inside another
device, then the outside of the device into which the module is installed must also display a
label referring to the enclosed module. In that case, the final end product must be labeled in a
visible area with the following:
“Contains Transmitter Module FCC ID: VDE-0H7699”
“Contains Transmitter Module IC: 8036A-0H7699”
or
“Contains FCC ID: VDE-0H7699”
“Contains IC: 8036A-0H7699”
The OEM of the 0H7699 Module must only use the approved antenna(s) listed above, which
have been certified with this module.
The OEM integrator has to be aware not to provide information to the end user regarding
how to install or remove this RF module or change RF related parameters in the user
manual of the end product.