- Generac Air-Cooled Recreational Vehicle Generator Owner's Manual And Installation Instructions

15
2. When valve clearance is correct, hold the pivot
ball stud with the allen wrench and tighten the
rocker arm jam nut with a crows foot. Tighten
the jam nut to 65-85 inch-pounds torque. After
tightening the jam nut, recheck valve clearance to
make sure it did not change (Figure 3.7).
Figure 3.7 — Tightening Jam Nut
3.13 RV GENERATOR SERVICE
INTERVAL
50 Hours ................................ Clean Spark Arrestor
100 Hours ...........................Change Engine Oil/filter
100 Hours .................................. Clean Air Pre-filter
100 Hours ................................ Inspect Spark Plugs
250 Hours ............ Replace Paper Air Filter Element
500 Hours ................................Replace Spark Plugs
1st 50 Hours-then
every 500 Hrs. .......................... Adjust Valve Lash
Section 3 – Maintenance
Recreational Vehicle Generator