Install Manual
Table Of Contents
- Installation Guidelines 60 Hz Air-Cooled Generators
- Table of Contents
 - Section 1: Safety Rules & General Information
 - Section 2: Unpacking and Inspection
 - Section 3: Site Selection and Preparation
 - Section 4: Generator Placement
 - Section 5: Fuel Conversion / Gas Connections
 - Section 6: Electrical Connections
 - Section 7: Control Panel Startup / Testing
 - Section 8: Troubleshooting
 - Section 9: Quick Reference Guide
 - Section 10: Accessories
 - Section 11: Diagrams
 
 
Site Selection and Preparation
Installation Guidelines for 60 Hz Air-Cooled Generators 13
Section 3: Site Selection and Preparation
Site Selection
Site selection is critical for safe generator operation. It is
important to discuss these factors with the installer when
selecting a site for generator installation:
• Carbon monoxide 
• Fire prevention
• Fresh air for ventilation and cooling
• Water ingress prevention
• Proximity to utilities
• Suitable mounting surface
The  following  pages  describe  each  of  these  factors  in
detail. 
NOTE: The term “structure” is used throughout this sec-
tion to describe the home or building where generator is
being  installed.  Illustrations  depict  a  typical  residential
home. However, instructions and recommendations pre-
sented in this section apply to all structures regardless of
type. 
Carbon Monoxide
IMPORTANT  NOTE:  Move  to  fresh  air  immediately
and seek medical attention if you feel sick, dizzy, or
weak while the generator is running or after it stops.
Generator  exhaust  contains  carbon  monoxide  (CO)—a
poisonous, potentially lethal gas that cannot be seen or
smelled. The generator must be installed in a well venti-
lated area away from windows, doors, and openings. The
selected  location  should  not  allow  exhaust  gases  to  be
drawn  into  structures  where  people  or  animals  may  be
present.
Carbon Monoxide Detectors
See Figure 3-1. CO detectors (K) must be installed and
used to monitor for CO and to warn individuals about the
presence  of  CO.  CO  detectors  must  be  installed  and
tested  in  accordance  with  the  CO  detector  manufac-
turer’s  instructions  and  warnings.  Contact  local  building
inspection  department  for  any  applicable  requirements
concerning  CO  detectors.  See  NFPA  72,  National  Fire
Alarm and Signaling Code, and Section R315 in the ICC
International Residential Code for more information.
IMPORTANT NOTE: Common smoke alarms do NOT
detect CO gas. Do not rely on smoke alarms to pro-
tect residents or  animals  from  CO. The only
 way  to
detect CO is to have functioning CO alarms.
(000103)
Asphyxiation. Running engines produce carbon 
monoxide, a colorless, odorless, poisonous 
gas. Carbon monoxide, if not avoided, will 
result in death or serious injury.
DANGER










