Install Manual

Electrical Connections
32 Installation Guidelines for 60 Hz Air-Cooled Generators
Battery Installation
• (Group 26R batteries only): Fill battery with the
correct electrolyte fluid if necessary.
• Fully charge battery before installing it.
Complete the following steps before installing and con-
necting battery:
1. Verify generator is OFF.
2. Turn OFF utility power supply to transfer switch.
3. Remove 7.5A fuse from generator control panel.
Connecting Battery
See Figure 6-2. Battery cables (A, B) were factory con-
nected at the generator.
Figure 6-2. Battery Cable Connections
Connect battery cables to battery posts as follows:
1. Connect red positive battery cable (A: from starter
contactor) to positive battery post. Tighten to 70 in-
lbs (8 Nm).
2. Connect black negative battery cable (B: from
frame ground) to negative battery post. Tighten to
70 in-lbs (8 Nm).
3. Install red battery post cover (shipped with loose
parts).
NOTE: Apply dielectric grease to battery posts to pre-
vent corrosion.
NOTE: In areas where temperatures fall below 0 °F
(-18 °C), a pad type battery warmer is recommended to
aid in cold climate starting. The battery warmer is avail-
able as part of a cold weather kit from any IASD.
A battery warmer is not necessary for AGM-style batter-
ies.
Battery Disposal
Always recycle batteries in accordance with local laws
and regulations. Contact your local solid waste collection
site or recycling facility to obtain information on local
recycling processes. For more information on battery
recycling, visit the Battery Council International website
at: http://batterycouncil.org
(000137a)
WARNING
Explosion. Batteries emit explosive gases while charging.
Keep fire and spark away. Wear protective gear when
working with batteries. Failure to do so could result in
death or serious injury.
(000138a)
WARNING
Risk of burns. Batteries contain sulfuric acid and
can cause severe chemical burns. Wear protective
gear when working with batteries. Failure to do
so could result in death or serious injury.
(000133)
WARNING
Explosion. Batteries emit explosive gases.
Always connect positive battery cable first to
avoid spark. Failure to do so could result in
death or serious injury.
(000163a)
WARNING
Risk of burn. Do not open or mutilate batteries.
Batteries contain electrolyte solution which can
cause burns and blindness. If electrolyte contacts
skin or eyes, flush with water and seek immediate
medical attention.
(000133)
WARNING
Explosion. Batteries emit explosive gases.
Always connect positive battery cable first to
avoid spark. Failure to do so could result in
death or serious injury.
(000167a)
CAUTION
Equipment damage. Do not make battery
connections in reverse. Doing so will result
in equipment damage.
–
+
001832
B
A
WARNING
Environmental Hazard. Always recycle batteries at an
official recycling center in accordance with all local
laws and regulations. Failure to do so could result in
environmental damage, death or serious injury.
(000228)