Install Manual
Table Of Contents
Fuel Conversion / Gas Connections
24 Installation Guidelines for 60 Hz Air-Cooled Generators
Installing and Connecting Fuel Lines
IMPORTANT NOTE: NG and LP gas are highly vola-
tile  substances.  Strictly  adhere  to  all  safety  proce-
dures, codes, standards, and regulations.
Fuel line connections should be made by a certified con-
tractor  familiar  with  local  codes.  Always  use  AGA-
approved  gas  pipe  and  a  quality  pipe  sealant  or  joint
compound.
Verify capacity of NG meter  or  LP tank to provide  suffi-
cient  fuel  for  both  the  generator  and  other  operating
appliances.
Fuel Shutoff Valve
See  Figure 5-2.  The  generator  will  require  an  external
manual fuel shutoff valve (A) on the fuel line. 
NOTE: Fuel shutoff valve must be installed at a readily
accessible location, and within 6 ft (1.8 m) of generator
fuel inlet.
Figure 5-2. Sediment Trap, Fuel Shutoff Valve with 
Manometer Port, and Flexible Fuel Line
Figure 5-3 illustrates a fuel shutoff valve with a manome-
ter  port  for  making  fuel  pressure  checks.  This  optional
accessory  fuel  shutoff  valve  permits  making  pressure
checks  for  diagnostic  purposes  without  going  into  the
generator enclosure.
.
Figure 5-3. Fuel Shutoff Valve with Manometer Port
Fuel shutoff valves available through a local IASD:
• 1/2 in ball valve, part number 0K8752
• 3/4 in ball valve, part number 0K8754
• 1 in ball valve, part number 0K8184
• 1-1/4 in ball valve, part number 0L2844
• 1-1/2 in ball valve, part number 0L2845
Flexible Fuel Line
See Figure 5-2. When connecting flexible fuel line (B) to
generator,  use  a  listed  assembly  meeting  the  require-
ments  of ANSI  Z21.75/  CSA 6.27—Connectors  for  Out-
door Gas Appliances and Manufactured Homes or AGA-
approved flexible fuel line in accordance with local regu-
lations. 
Flexible fuel line must not be connected directly to gener-
ator  fuel  inlet.  Always  connect  flexible  fuel  line  to  an
approved gas fitting.
The purpose of flexible fuel line is to isolate vibration from
the generator to reduce possibility of a gas leak at one of
the connection points. 
NOTE:  Follow  all  installation  instructions  and  warnings
provided  with  the  flexible  fuel  line.  Do  not  remove  any
labels or tags. Flexible fuel line must be installed horizon-
tally,  and  must  be  installed  between  fuel  shutoff  valve
and generator fuel inlet.
Sediment Trap
See  Figure 5-2.  Some  local  codes  require  a  sediment
trap (C). The fuel regulator connection has an integrated
sediment trap.
The sediment trap must be cleaned periodically accord-
ing to local codes. See owner’s manual for more informa-
tion.
(000192)
DANGER
Explosion and fire. Fuel and vapors are extremely
flammable and explosive. No leakage of fuel is
permitted. Keep fire and spark away. Failure to do
so will result in death or serious injury.
001816
001816
C
B
A
000743










