Install Manual

Control Panel
34 Installation Guidelines for Air-Cooled Generators
ACTIVATION CHART
Display Reads:
Generator Active is displayed on the
LCD screen when the unit is first
powered up. After displaying firmware
and hardware version codes, as well as
other system information, the Installation
Wizard is launched, and the Language
screen is displayed.
Use the ARROW keys to scroll to desired
language.
Press ENTER.
If the wrong language is selected, it may be changed
later using the Edit menu.
Display Reads:
Press ENTER. Press the ESCAPE key to abort the activation
sequence. NOT ACTIVATED is displayed and the
generator will run in manual mode only. Disconnect and
reconnect the negative battery cable to restart the
activation routine. If power is removed after a
successful activation, no data is lost, but the time and
date must be updated.
Display Reads:
Go to www.activategen.com or call 1-
888-9ACTIVATE (922-8482, US & CA
only) if activation passcode is not avail-
able.
If activation pass code is available, wait a
few seconds for the next display.
Display Reads:
Use ARROW keys to increment or
decrement the digit to correspond to the
first number of the pass code.
Press ENTER.
Repeat step to enter remaining digits.
Press the ESCAPE to return to preceding digits if a
correction becomes necessary.
If attempts to enter the activation code are
unsuccessful, check the number against the code
given on activategen.com. If it is correct, contact 1-888-
9ACTIVATE (922-8482, US & CA only).
Figure 7-4. Activation Sequence
Language
- English +
Up Arrow = (+)
Down Arrow = (-)
Activate me (ENT) or
ESC to run in manual
To Activate go to
www.activategen.com
SN 1234567890
PASS CODE XXXXX