Install Manual
Table Of Contents
- Installation Guidelines
- FREQUENTLY ASKED QUESTIONS
- Table of Contents
- Section 1 Safety and General Information
- Section 2 Unpacking and Inspection
- Section 3 Site Selection and Preparation
- Section 4 Generator Placement
- Section 5 Fuel Conversion/Gas Connections
- Section 6 Electrical Connections
- Section 7 Control Panel
- Section 8 Troubleshooting
- Section 9 Quick Reference Guide
- Section 10 Accessories
- Section 11 Diagrams
- Part No. 0K5804
Electrical Connections
28 Installation Guidelines for Air-Cooled Generators
Figure 6-1. Control Wiring (Behind Control Board)
NOTE: Wires 23, 194 and 0 must be run through the provided wire shielding provided in the manual bag to sep-
arate the low voltage from the high voltage wires unless the requirement of 300.3(c)(1) of the NEC are met (see
the Parts Shipped Loose section).
NOTE: Must be connected to keep battery charged whether unit is running or not.
6.3 — Main AC Wiring
Figure 6-2. Main AC Wiring
NOTE: Main AC (E1, E2 and Neutral) wiring must be in accordance with local jurisdiction and codes.
1. Strip the insulation off the wire ends. Do not remove excessive insulation.