Install Manual
Table Of Contents
- Installation Guidelines
- FREQUENTLY ASKED QUESTIONS
- Table of Contents
- Section 1 Safety and General Information
- Section 2 Unpacking and Inspection
- Section 3 Site Selection and Preparation
- Section 4 Generator Placement
- Section 5 Fuel Conversion/Gas Connections
- Section 6 Electrical Connections
- Section 7 Control Panel
- Section 8 Troubleshooting
- Section 9 Quick Reference Guide
- Section 10 Accessories
- Section 11 Diagrams
- Part No. 0K5804
Safety and General Information
2 Installation Guidelines for Air-Cooled Generators
1.1.2— How to Obtain Service
When the generator requires servicing or repairs, contact a Dealer for assistance. Service technicians are factory-
trained and are capable of handling all service needs. For assistance locating a dealer, call our dealer locater at 800-
333-1322 or visit us at www.generac.com/dealer-locator.
When contacting a Dealer about parts and service, always supply the complete model number and serial number of the
unit as given on its data decal, which is located on the generator. See section “The Generator” for decal location.
Model No. _____________________ Serial No. __________________________
1.2 — Safety Rules
Save These Instructions – The manufacturer suggests that these rules for safe oper-
ation be copied and posted near the unit’s installation site. Safety should be
stressed to all operators and potential operators of this equipment.
Study these SAFETY RULES carefully before installing, operating or servicing this equipment. Become familiar with
this Installation Manual and with the unit. The generator can operate safely, efficiently and reliably only if it is properly
installed, operated and maintained. Many accidents are caused by failing to follow simple and fundamental rules or pre-
cautions.
The manufacturer cannot anticipate every possible circumstance that might involve a hazard. The warnings in this
manual and on tags and decals affixed to the unit are, therefore, not all-inclusive. If using a procedure, work method or
operating technique the manufacturer does not specifically recommend, ensure that it is safe for others. Also, make
sure the procedure, work method or operating technique utilized does not render the generator unsafe.
Despite the safe design of this generator, operating this equipment imprudently, neglecting its mainte-
nance or being careless can cause possible injury or death. Permit only responsible and capable per-
sons to install, operate and maintain this equipment.
Potentially lethal voltages are generated by these machines. Ensure all steps are taken to render the
machine safe before attempting to work on the generator.
Parts of the generator are rotating and/or hot during operation. Exercise care near running generators.
Installation must always comply with applicable codes, standards, laws and regulations.
A running generator gives off carbon monoxide, an odorless, colorless poison gas. Breathing in carbon
monoxide can cause headaches, fatigue, dizziness, nausea, vomitting, confusion, fainting, siezures or
death.
1.2.1— General Hazards
•
For safety reasons, the manufacturer recommends that this equipment be installed by an independent Sales or
Service Dealer or other competent, qualified electrician or installation technician who is familiar with applicable
codes, standards and regulations. The operator also must comply with all such codes, standards and regula-
tions. Only an Independent Authorized Service Dealer is allowed to perform warranty service on this unit.
• The engine exhaust fumes contain carbon monoxide, which can be DEADLY. This dangerous gas, if breathed in
sufficient concentrations, can cause unconsciousness or even death. Do NOT alter or add to the exhaust system
or do anything that might render the system unsafe or in noncompliance with applicable codes and standards.
• Install a battery-operated carbon monoxide alarm indoors, according to manufacturer’s instructions/recommen-
dations.
+










