Install Manual
Table Of Contents
- Installation Guidelines
- FREQUENTLY ASKED QUESTIONS
 - Table of Contents
 - Section 1 Safety and General Information
 - Section 2 Unpacking and Inspection
 - Section 3 Site Selection and Preparation
 - Section 4 Generator Placement
 - Section 5 Fuel Conversion/Gas Connections
 - Section 6 Electrical Connections
 - Section 7 Control Panel
 - Section 8 Troubleshooting
 - Section 9 Quick Reference Guide
 - Section 10 Accessories
 - Section 11 Diagrams
 - Part No. 0K5804
 
 
Control Panel
36 Installation Guidelines for Air-Cooled Generators
Figure 7-5. Installation Wizard Menu
"Generator"
"AcƟve"
"Install Wizard"
"......."
"AcƟvate me (ENT) or"
"ESC to run in manual"
"NOT ACTIVATED !"
"Language"
"<- XXXXX ->"
"To acƟvate go to"
"www.acƟvategen.com"
"- English +"
"- Espanol +"
"- Francois +"
" Fuel SelecƟon"  
"<- XX ->"
Note: Set Fuel Type 
"Serial 1234567890"
"PASSCODE xxxxx"
"Wrong Passcode"
"Try Again"
"- LP +"
"- NG +"
"Select Hour (0-23)"
"Select Minute (0-59)"
"Select Month (1-12)"
Note: Set Generator Time
"Select Date (1-31)"  
"Select Year (0-99)"
"Install Wizard"
"Set Exercise"
"Quiet Test Mode"
"- NO +"
"YES +"
Note: Low speed 
exercise selecƟŽn
 "Select Frequency" 
"- WEEKLY +"
- BIWEEKLY +"
MONTHLY +"
Note: Set Exercise Time
 "Select Hour (0-23)"
"Select Minute (0-59)"
If Freq=Weekly or Biweekly 
"Select Day"
"Sunday"
"Monday"
"Tuesday"
 If Freq=Monthly
Select "1- 28"
"Wednesday" 
"Thursday"
"Friday" 
"Saturday"
"XXXXX"
"XXXXX"
Note: Finishes at status screen
ENTER 
ENTER 
This will only come up the Įrst Ɵme the generator is powered. If ESC is pressed to skip the   
acƟvaƟon process, the baƩĞry must be disconnected to allow acƟvaƟon again and this process
will
reiniƟĂůŝze. If power is removed aŌĞr a successful acƟvaƟon, the data is remembered and the
acƟvaƟon steps are skipped.
ENTER 
3 sec delay 
ESCAPE
ENTER 
wrong entry
IF NOT YET ACTIVATED
Note1: Can run in MANUAL only 
 if NOT ACTIVATED
Note2: Must disconnect baƩĞry 
 to allow acƟvaƟon again
ENTER 
ENTER 
ENTER 
Note1: Language only shows up
Įƌst Ɵme it is powered unless
enter is pressed to skip through 
the install wizard
ENTER 










