Install Manual
Table Of Contents
- Installation Guidelines
- FREQUENTLY ASKED QUESTIONS
- Table of Contents
- Section 1 Safety and General Information
- Section 2 Unpacking and Inspection
- Section 3 Site Selection and Preparation
- Section 4 Generator Placement
- Section 5 Fuel Conversion/Gas Connections
- Section 6 Electrical Connections
- Section 7 Control Panel
- Section 8 Troubleshooting
- Section 9 Quick Reference Guide
- Section 10 Accessories
- Section 11 Diagrams
- Part No. 0K5804
Electrical Connections
30 Installation Guidelines for Air-Cooled Generators
Figure 6-3. Battery Cable Connections
NOTE: In areas where temperatures regularly fall below 32 °F (0 °C), a pad type battery heater and engine oil
warmer are required to be installed to aid in cold climate starting. This is available as a cold weather kit
through an independent authorized service dealer and is also available on Generac.com.
12VDC
Red (+)
Red Lead
From Starter
Contactor
Black (-)
Black Lead
To Frame
12VDC System