Install Manual
Table Of Contents
- Installation Guidelines
- FREQUENTLY ASKED QUESTIONS
- Table of Contents
- Section 1 Safety and General Information
- Section 2 Unpacking and Inspection
- Section 3 Site Selection and Preparation
- Section 4 Generator Placement
- Section 5 Fuel Conversion/Gas Connections
- Section 6 Electrical Connections
- Section 7 Control Panel
- Section 8 Troubleshooting
- Section 9 Quick Reference Guide
- Section 10 Accessories
- Section 11 Diagrams
- Part No. 0K5804
Generator Placement
18 Installation Guidelines for Air-Cooled Generators
4.2 — Fascia Installation (If Applicable)
• Locate the four (4) threaded black rubber bumpers located in the Owner’s manual bag.
• Remove the four (4) bumpers from the bag and screw them into threaded holes located inside the end pieces of
the fascia (two each) opposite one another (A).
• Once the bumpers are installed, snap one of the end pieces into one of the front / rear pieces of fascia. Repeat
this action with the other two remaining pieces of fascia.
NOTE: Do not assemble all four pieces together at this point (B).
• Place both assemblies at the base of the generator and fit the rubber bumpers into the lifting holes in the gener-
ator base (C).
• Once aligned, snap together the two remaining connection points.
Figure 4-3. Fascia Installation
A
B
C