User Manual

7
Figure 11. The curve above shows the delay variation of the 8341A
as a function of frequency.
SYSTEM SPECIFICATIONS
Lower cut-off frequency, –6 dB < 38 Hz
Upper cut-off frequency, –6 dB > 37 kHz
Accuracy of frequency response, ± 1.5 dB 45 Hz – 20 kHz
Maximum short term sine wave acoustic output on axis in half space, averaged from
100 Hz to 3 kHz at 1 m
≥ 110 dB SPL
Maximum long term RMS acoustic output in the same conditions with IEC weighted
noise (limited by driver protection circuit) at 1 m
101 dB SPL
Maximum peak acoustic output per pair in a listening room with music material at 1 m 118 dB
Self generated noise level in free space at 1 m on axis (A-weighted) ≤ 3 dB
Harmonic distortion at 90 dB SPL at 1 m on axis
Freq: 50…100 Hz
> 100 Hz
< 2 %
< 0.5 %
Drivers
Bass
Midrange
Treble
Dual 170 x 90 mm (6
5
/
8
x 3
1
/
2
in) oval cones
90 mm (3
1
/
2
in) cone (coaxial)
19 mm (
3
/
4
in) metal dome (coaxial)
Weight 9.8 kg (22 lb)
Dimensions
Height including IsoPod stand
Height without IsoPod
Width
Depth
370 mm (13
13
/
16
in)
351 mm (14
9
/
16
in)
237 mm (9
3
/
8
in)
243 mm (9
1
/
2
in)
Bass amplifier short term output power
Midrange amplifier short term output power
Treble amplifier short term output power
(Long term output power is limited by driver protection circuitry)
250 W
150 W
150 W
Amplifier system THD at nominal output <0.05%
Mains voltage 100-240 VAC 50/60 Hz
Power consumption
ISS active
Idle
Full output (short term)
< 0.5 W
16 W
250 W
AMPLIFIER SECTION
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Modifications not expressly approved by the manufacturer
could void the user’s authority to operate the equipment under
FCC rules.
20k
50
100
200
500
1k 2k
5k
10k
Frequency Hz
Genelec Oy 8341 16 May 2017
ms
5
0
10
15
35
20
25
30
40