Product Manual
BATTERY PANEL
GV-Boost
Installation & System Connections:
MOUNTING
Mount the controller near your battery securely using the holes provided on the enclosure’s flanges
or with a means appropriate to the application.
Mount near battery.
The GVB can be mounted in any orientation.
Do not expose to water (PLEASE SEE MODEL GVB-WP FOR WATERPROOF VERSION).
Do not mount in direct sunlight or near a source of heat.
Allow adequate airflow around the controller to achieve maximum output capability.
For outdoor use, the controller must be housed in an enclosure providing protection
at least equivalent to NEMA Type 3.
e
CONNECTING THE SOLAR PANEL
Connect the solar panel to the +PANEL and –PANEL terminals.
In most applications, the panel should be connected only to the GVB.
The LED may blink red until a battery is connected.
Do not use blocking diodes for single-panel installations. The GVB prevents
reverse-current flow.
If multiple panels are being used in parallel, blocking diodes are recommended in
series with each panel, unless the panel manufacturer recommends otherwise.
Solar panel voltage rises in cold weather. Check that the solar panel open circuit
voltage (Voc) will remain below the maximum input voltage of the GVB at the
coldest possible expected temperature.
• Connections should be made according to Article 690 of the National Electrical Code (NFPA 70)
or the standards in force at the installation location.
• Electrical connections may be made in any order; however the sequence below is recommended.
CONNECTING THE BATTERY
Connect the battery to the +BATT and –BATT terminals.
A small spark while connecting the battery is ok.
Any loads should be connected directly to the battery. The GVB does not provide
protection against over-discharge.
CAUTION, RISK OF FIRE OR EXPLOSION: Do not make the final battery connection
near lead-acid batteries that have recently been charging.
r
t
Note: Do not install this controller in a Golf Cart. Genasun Oers the GVB-WP for Golf
Carts and other applications where water resistance is needed.
Note: Make sure to inspect the controller at least once per year to ensure proper
performance. Please see the Inspection & Maintenance section in this guide.
The GVB has a
MULTICOLOR LED.
Learn about this indicator
on the following page.