User Manual

Battery Plates for SpectroLED Studio Lights - USER MANUAL
4
Battery Plates for SpectroLED Studio Lights - USER MANUAL
5
MOUNTING THE
BATTERY PLATES
· If there are screws in any of the eight
mounting holes on your light (inside
the yellow box), remove them first.
Be sure not to remove any of the
surrounding structural screws.
· Make certain that the power switch
on the light is in the Off position. Place
the battery plate on the mounting
holes and screw the mounting screws
into the light. Each battery can only be
mounted using the correct holes on
the light; if all four screws cannot be
screwed in, the plate is in the wrong
position.
· All Genaray Studio lights can be
operated using the Sony V-Lock
or Anton/Bauer Gold battery. To
use either battery, you will need to
mount the correct battery plate to
the back of the Studio light.
· Each battery plate uses our screws
in order to secure the plate to the
back of the light. The holes for the
screws are configured in a different
pattern for each battery plate;
therefore, there are eight mounting
holes on the back of the light,
only four of which you will use for
mounting your specific battery plate.
instructions