User Manual

SpectroLED STUDIO LIGHT - USER MANUAL
14
· Note: Since the remote controls the Daylight
and Bi-Color fixtures differently, it is not
recommended to sync a single remote to
both types of lights. Rather, use at least two
separate remotes in a setup incorporating
both Daylight and Bi-Color lights.
· To remove a light from a group or to assign
a different remote to an existing light, you
will have to re-sync the desired light to a
new remote. First turn off any lights that
you do not wish to change. Then follow the
usual steps for syncing a new remote – turn
on only the fixture you wish to change, and
press and hold the “A” and “B” buttons on
the remote. The light is now synced to the
new remote and all associations with the
previous remote or group is removed.
USING THE
REMOTE
· There are four buttons on the remote
control. All of the functions of the remote
are activated by either pressing one button
or by pressing two buttons at the same time.
Each time a remote operation has been
successfully executed, a red LED on the
remote will illuminate, and the light fixture
receiving the command will emit a beep.
This beep can be disabled, if desired.
· In order to use the remote control, the
power switch on the light fixture must be in
the On position. If the switch is set to Off, the
light will not respond to any command from
the remote control. The remote can be used
to power the light on or off.
· The remote control uses radio waves, so
line-of-sight positioning of the light is not
required.
INSTRUCTIONS