User Manual

SpectroLED STUDIO LIGHT - USER MANUAL
11
POWERING THE
LIGHT
· The Studio light operates on any 120/220
VAC circuit using the included adapter. A
built-in fuse (located between the power
switch and the power connector on the
back of the fixture) provides overcurrent
protection for electric circuits, and two spare
fuses are included. To change the fuse, use
a small screwdriver to turn the cover of the
fuse bay counterclockwise while pressing
in. Remove the old fuse, insert a new fuse
into the bay, and replace the cover. Use a
screwdriver to turn the cover clockwise
while pressing in.
· To operate the light, open the barndoors, be
sure the power button is Off, and plug the
power cord into a 120 or 220 VAC circuit.
Then, align the pins in the connector so
that the release button is on the top of the
connector and plug it into the power socket
on the back of the light. Press the power
switch to the On position and the light and
the touch-screen will illuminate.
· The angled locking 4-pin power connector
prevents accidental disconnection of the
cable. The two included cable management
straps can be used to attach the adapter and
adapter cable to a light stand.
· The SpectroLED can also operate using a
Sony V-Type or Anton Bauer Gold battery
with an appropriate optional battery plate
(available separately from Genaray). Battery
plate mounting holes are located on the
back of the fixture. Instructions for mounting
a battery plate are included with the battery
plate.
INSTRUCTIONS