User Manual

SpectroLED OUTFIT LIGHT - USER MANUAL
8
SpectroLED OUTFIT LIGHT - USER MANUAL
9
MOUNTING THE
BATTERIES
· Be sure that the On-Off/Dimmer dial
is set to Off. Begin by holding a fully
charged battery in position over one
of the two battery mounting areas.
Leave only a small gap between the
conductor contacts on the battery and
the metal prongs on the fixture. Push
the battery down and lock into place
by sliding it inwards along the grooves
until an audible click is heard. Mount
the second battery in the same way.
· A DC input on the rear of the fixture
allows you to use DC power via the
included DC power cord and adapter.
Two cable management straps are
included to help keep your cables
under control and out of the way.
· To position the light fixture, loosen
the ratchet handle, which will allow
the ball to move freely. Always
keep one hand on the light when
positioning it to prevent it from
falling. Move the light to the desired
position and securely tighten the
ratchet handle.
instructions