User Manual

SpectroLED OUTFIT LIGHT - USER MANUAL
10
SpectroLED OUTFIT LIGHT - USER MANUAL
11
· Turn the On-Off/Dimmer dial to the On
position and the light will come on. You
can adjust the output from 100% of
total output to 0% of total output (for the
Daylight version), or from 100% to 10%
(for the Bi-Color version), by rotating the
On-Off/Dimmer dial.
· The Bi-Color version has an additional
dial on the back of the fixture that allows
you to change the color temperature. You
can set it to any point between 3200°K
and 5600°K. Turn the dial until you
achieve the desired color effect.
· An LED power indicator keeps you
informed of how much battery power you
have left. Press the test button labeled
"T". The number of illuminated LEDs
will tell you how much power is left: four
lights equals full power; three lights,
75% power; two lights, 50% power; and
one light, 25% power remaining.
· A diffusion filter is included to soften
and spread the light. For a more direct
light with more contrast and higher
output, remove the diffusion filter. The
filter is held in place by four screws–take
the screws out to remove the filter. The
tungsten filter included with the Daylight
fixture is mounted, and may be removed,
in the same way.
· When you are finished using the light,
turn the dial to Off. Remove each battery
by pushing the red battery release button
and the battery will be ejected.
instructions
ADJUSTING THE
LIGHT