User Manual

SpectroLED - USER MANUAL
7
INSTRUCTIONS
POWERING
THE BEACON
The SP-LR2 can be powered with
the lithium-ion battery or with
the included AC adapter.
Battery Power:
When using battery power, the four LED
indicators on the handle indicate remaining
battery charge in 25% increments. The
battery will last approximately 1.5 hours on
a full charge with the light at full power.
AC Power:
To operate the Beacon with AC power, the
battery must be installed. Plug the adapter
into a standard power outlet and the other
end into the Beacon’s AC/DC socket.
Turning the Beacon On or Off:
To power on, press and hold the power
button until the fixture illuminates,
and release the power button.
To power off, press and hold the
power button for approximately 2
seconds, and then release it.
Pressing and holding the power
button for more than 2 seconds will
activate channel selection mode,
and all the LED indicators will blink.
Press the power button again to
quit channel selection mode, and
press and hold the power button
for a shorter length of time.
Note