User Manual

SP-C USER MANUAL
9
INSTRUCTIONS
Attach the battery handle to the wand by
following these steps:
1. Turn the locking ring counterclockwise
to make sure that the ring is above the
threads.
2. Make sure the dimmer is in the off position
(turned up until it clicks).
3. Align the battery contact sockets on the
battery handle with the wand’s battery
contact points.
4. Slide the battery handle onto the wand,
and turn the locking ring clockwise until
secure.
OPERATING THE
CUTLASS
The contacts and sockets align only
one way, and the battery handle
should attach to the wand effortlessly.
Don’t use force to attach the battery
handle. If it doesn’t slide on easily,
realign the sockets and points
until it does.
5. Turn the dimmer down to turn on the LED
array and adjust the brightness.
Color Temperature
· For 5600 K color temperature, rotate the
filter so the clear plastic diffuser is in
front of the LED array.
· For 3200 K color temperature, rotate the
orange tungsten filter in front of the LED
array. The arrow at the bottom of the filter
aligns with the one above the locking ring
when the filter is in position.
Note