User Manual

SP-C USER MANUAL
10
INSTRUCTIONS
OPERATING
THE RING
LIGHT
To power the ring light, follow these steps:
1. Attach the ring light’s power cord to the
power output socket on the battery handle.
2. Turn the ring light on by turning the dimmer
down and adjusting the brightness to the
desired level.
After use, turn the ring light off before you
disconnect it from the battery handle.
The ring light operates only in 5600 K
daylight-balance mode.
Note
CHARGING A
PHONE OR OTHER
DEVICE
The USB output port on the battery handle is for
charging a cell phone or other USB device. To
use the battery handle to charge a device, follow
these steps:
1. If necessary, detach the battery handle
from the wand by turning the locking wheel
counterclockwise and pulling the handle off
of the wand.
2. Use the included USB to micro-USB cable,
or your own charging cable, to attach your
phone or device to the USB port on the
battery.
3. Power on the battery by turning the dimmer
up so that the battery power indicators are
illuminated.