User Manual

Genaray SpectroLED 14 Guide | Page 8
ADJUSTING THE ANGLE
1. Loosen the upper locking knob on the mounting bracket of the LED light.
2. Carefully adjust the articulation.
3. Tighten the upper locking knob to secure the new position.
PLUGGING INTO AN AC POWER SOURCE
1. Power off the LED light by turning the power switch to the OFF position.
2. With the groove in the cable jack facing down, insert the jack into the two-pin
connection on the back of the lamp.
3. Rotate the locking collar on the jack clockwise to secure the connection.
4. Plug the female end of the AC cable into the step down transformer.
5. Plug the male end of the AC cable into the electrical socket.
6. Switch the LED light to the ON position when you are ready to use the light.
Instructions