User's Manual

LightSeeker Remote for Powerhouse, PortaBright, and Endeavor Monolights - USER MANUAL
5
CHANNEL
SELECTION
Press the channel select button
to highlight the current channel
setting. Use the up/down
buttons to set the channel.
Important! Make sure the Genaray
lights are set to the same channel
as the remote. Refer to the user
manuals that came with the lights
to select their channels and groups.
1. Remove the battery cover
and install two AA batteries.
Make sure they’re in the
proper orientation. Then
replace the battery cover.
2. Press and hold the on/off button
until the screen illuminates.
Note: After 5 minutes of inactivity,
the remote will switch to standby
mode to preserve battery life. To
wake up the remote, press any
button to display the control screen.
POWERING ON THE
REMOTE
instructions