User Manual

Radiance 230-Watt Daylight LED Monolight - USER MANUAL
13
The Radiance supports DMX-512,
so a DMX console can remotely
control the the light’s settings.
Note
When the Radiance is connected to a
DMX console, the remote is disabled.
To set up DMX operation on the
Radiance, follow these steps:
1. Use a Cat 5e or Cat6 cable with RJ45
connectors to attach a DMX controller to
either one of the RJ45 ports. The other
port will automatically become the
output port.
Note: DMX XLR to RJ45 adapters
are available separately.
2. Use the other RJ45 port to
connect multiple lights.
3. Refer to the DMX console’s user manual
to set the DMX address on the controller.
Set the DMX ID on the Radiance by
following the instructions in Setting
the Channel and DMX ID above.
Important
Make sure the DMX ID on the Radiance
matches the DMX console’s address.
USING DMX
instructions