User Manual

Radiance 230-Watt Daylight LED Monolight - USER MANUAL
12
SETTING THE CHANNEL ID
The remote and the Radiance must
be set to the same channel in order
to operate the light via the remote.
To set the channel number,
follow these steps:
1. Touch the on-screen channel ID
button. The first digit will blink.
2. Touch the on-screen up/down
buttons to make a selection.
3. Follow steps 1 and 2 to set the
second and third digits.
After three seconds, the digit will stop
blinking, and the selection will be set.
ADJUSTING BRIGHTNESS
To adjust the brightness via the remote:
1. Power on the remote by
pressing the power button.
2. Touch the brightness button on the
screen. The brightness value will blink.
3. Tap the on-screen up/down
buttons to fine-tune the brightness
in 1% increments, or touch
and hold to adjust rapidly.
USING THE ANTENNA
To increase the operating range of the
remote from 100 to 165 feet (30 to 50 m),
screw the antenna into the antenna port
on the rear of the power adapter.
instructions