User Manual

Radiance 230-Watt Daylight LED Monolight - USER MANUAL
11
SETTING THE CHANNEL
AND DMX ID
Use the same steps to set the channel
and DMX address numbers.
To set the channel or DMX number:
1. Touch the on-screen menu button.
The first digit will blink.
2. Touch the Enter button to change
the number in increments of 1.
3. Follow steps 1 and 2 to set the
second and third digits.
4. After setting all three digits, press the
Menu button to accept your selection.
Important
DMX addresses range from 0 to 512.
If the DMX ID is set to a value greater
than 512, the DMX controller will not
communicate with the Radiance.
REMOTE OPERATION
POWERING ON/CHARGING THE REMOTE
Press the power button to turn on the
remote. The LCD screen will illuminate.
To recharge the remote, use a USB cable
with a Micro-B connector to plug into an
outlet or a powered USB port on a computer.
The charging indicator will glow red
to indicate charging is in progress.
When the green indicator lights up,
the remote is fully charged.
instructions