User Manual

Full Moon 18 in. Bi-Color LED Light - USER MANUAL
9
USING DMX
1. Use a 3-pin XLR cable to connect a DMX
controller to the RSF-18 input port.
2. Use the RFS-18 output port to
connect multiple lights.
3. To set the DMX address on the RSF-18:
· Press the DMX control button. The DMX
icon will appear on the LCD screen.
· Press the Channel Select button.
The channel icon will blink.
· Use the dimmer/channel knob to
select a DMX channel from 01 to 512.
· Press the channel select button
to set the channel selection. The
channel icon will stop blinking.
Important
Make sure the DMX address on the
RSF-18 matches the DMX console.
The RSF-18 supports DMX-512 so
the light’s setting can be remotely
controlled from a DMX control console.
Note
When the RSF-18 is in DMX mode,
the adjustment dials are disabled.
Adjust the brightness and color
temperature via the DMX console.
To setup DMX operation on the
RSF-18, follow these steps:
instructions