User Manual

Change the Display Password

• Enter “General Settings” by pressing UP [ + ] and DOWN [ - ] button at same time for over 2 seconds.

• Then press MODE [ M ] and UP [ + ] for 2 seconds to enter power-on password setting state.

• [ P2 ] appears in center of screen. Enter CURRENT password. Once entered, short press MODE [ M ].

• PSd will now appear on screen. Short press MODE [ M ].

• PS1 will now appear on screen. This is where you enter your NEW password.

• Short press MODE [ M ] to shift between numbers, use UP [ + ] / DOWN [ - ] to increase/decrease the

input value.

• After entering the 4-digit password, press MODE [ M ] for over 2 seconds to confirm and exit.

ote: The default password of the display is 1234.

INTERFACE DISPLAY OPERATIONS (continued)

OPERATION

DIRECTIONS

Enter Password to Power on Bike

(If Enabled)

• Power on bike by holding MODE [ M ] for 2 seconds.

• [ P ] will appear on screen. This is where you enter your 4 digit password.

• Enter 4 digit password by short pressing MODE [ M ] to shift between numbers, use UP [ + ] / DOWN [ - ]

to increase/decrease the input value.

• A

fter entering the 4-digit password short press MODE [ M ] and bike will power on.

NOTE: If you forget your password, enter 5555 to enter main interface, then enter “General Settings” by

pressing UP [ + ] and DOWN [ - ] button at same time for over 2 seconds. Next follow steps noted below

to “Change the Display Password” to set up your new password.

• Enter “General Settings” by pressing UP [ + ] and DOWN [ - ] button at same time for over 2 seconds.

• Press MODE [ M ] and UP [ + ] button for over 2 seconds until [ P2 ] appears in middle of screen.

Note: The default password of the display is 1234. You can change your password later.

• Select Y / N through UP [ - ] / DOWN [ + ], Y means that it needs the power-on password, N means that

is does not need the power-on password. Y and N appear on lower left section of screen.

• T

o confirm and exit “General Settings” and save your settings, press MODE [ M ] for over 2 seconds.

Enable Password Protection