User Manual

INTERFACE DISPLAY OPERATIONS

OPERATION

DIRECTIONS

Turn on the bike • Press & hold MODE [ M ] until power engages.

Turn off the bike

• Press & hold MODE [ M ] until power disengages.

Note: Display will automatically shut down when battery is below 1 bar or bike is idle for 10 minutes.

Toggle between:

• Short press MODE [ M ] to change between ODO (Odometer),

Trip Distance, and Trip Time. Numbers appear at lower left of screen.

ote: Display defaults to Odometer [ ODO ] at startup.

Real-time Speed

Max Speed

Average Speed

Toggle between: ODO (Odometer)

Trip Distance

Trip Time

Turn on Walk Assist Mode

• While dismounted, Press DOWN [ - ] for 2 seconds activate “Walk Assist Mode”.

• The Walk Assist symbol will appear on screen and the bike will power at a uniform speed of 6 km/h.

• To deactivate Walk Assist Mode, unpress the [ - ] button.

Warning: Only use “Walk Assist” mode while pushing bike, do not use while riding.

Turn on LCD backlight and headlight

• Press UP [ + ] for 2 seconds to activate the LCD display backlight and headlight.

• The Light symbol will appear on screen.

To deactivate Light, press UP [+] for 2 seconds

Power Assist System (PAS) Level Setting

• Press UP [ + ] or the DOWN [ - ] button to switch the “Power Assist (PAS)” level and change the motor

output power.

• UP [ + ] button increases power. DOWN [ - ] button decreases power.

Note: When display is activated, the default Power Assist (PAS) is Level 1.

Battery Level Indication

• Battery level symbol is always displayed on screen.

• When the battery voltage is high, the five-segment LCD is on.

• When the battery is undervoltage, the outer frame of the battery flashes, indicating that the battery is

seriously undervoltage and needs to be charged immediately.

• I

f undervoltage, the electric bike will go on a uniform speed of 3.7 MPH (6 Km/h).

• Press MODE [ M ] and DOWN [ - ] at same time for 2 seconds to change display speed indicator

between Average Speed, Max Speed and Real-Time Speed.

ote: Display defaults to “Real-time Speed” at startup.