User Manual

“THE GROOVE” & “THE STRIDE” SPECIAL INSTRUCTIONS (NOTE: ALL OTHER BIKE MODEL OWNERS SKIP THIS SECTION)

“The Groove” & “The Stride”

Install Fender

Bike models “The Groove” and “The Stride” require front fender

installation. The fender is attached at three points: to the mounting

bracket at the top of the front fork where the light is attached, and

to the right and left mounting bolts on the lower fork.

a. Unscrew the bolt at the center of the top of the fork.

NOTE: t

his is the same bolt used to attach the light.

b. Sandwich the light mount and the fender mount between the

locking bolt and the frame mounting bracket.

c. Attach the nut and partially tighten.

d. Next, attach the left and right fender support arms to the

mounting bolts located at the bottom of each fork.

e. Gradually tighten the nuts holding the mounting arm in place,

being sure to center the fender above the wheel.

f. Once centered, tighten down the two nuts holding the mounting

arms, and the nut at the top of the fork.