User Manual

SAFETY | PRE-RIDE CHECK LIST
• Check headset, wheel bearings, pedal bearings, and bottom bracket bearings. All should be
lubricated, run freely, and not grind or rattle.
SAFETY CHECK
Bearings
Steering
Wheels & Tires
STEPS INVOLVED
• Confirm tires are inflated within the recommended limits posted on the tire sidewalls and hold air.
• Confirm tires have good tread, have no bulges or excessive wear, and are not cracked.
• Confirm rims spin true and have no obvious wobble.
• Confirm all wheel spokes are not broken or loose.
• Check axle nuts and front wheel quick release to confirm they are tight. Confirm the locking lever
on the quick release skewer is correctly tensioned, closed, and secured.
• Confirm the handlebar and stem are aligned, correctly adjusted, tightened, and allow
proper steering.
Pedals & Cranks
• Confirm pedals are securely tightened to the cranks.
• Confirm the cranks are securely tightened and are not damaged. .
• Confirm front and rear brakes work properly.
• Check brake pads and rotors for wear and confirm they are not overworn.
• Confirm brake pads are correctly positioned in relation to the rotors.
• Confirm brake levers are lubricated and tightly secured to the handlebar.
• Test that the brake levers are firm and that the brake-motor cutoff is working.
Brakes
Before every ride, please inspect the bike for the following:
Derailleur & Cables
• Check that the derailleur is adjusted and functioning properly.
• Confirm shifter and brake levers are attached to the handlebar securely.
• Confirm all shifter and brake cables are properly lubricated.
• Look over the connectors to make sure they are seated securely and free of debris or moisture.
• Check cables and cable housing for clear signs of damage.
Fork, Frame & Seat
• Check that the frame and fork are not bent, severely dented, or cracked.
• If either frame or fork are bent or cracked, they should be replaced.
• Check that the seat post quick release lever is securely tightened and that the seat does not spin
or move.
6