User Manual

INTERFACE DISPLAY OPERATIONS (continued)

OPERATION

DIRECTIONS

Error Code

• When the electric bike electronic control system fails, the display will automatically indicate the error

code and a number ranging from 21 -26.

• F

or the definition of detailed error codes, please see Troubleshooting the Electronics chart on Page 28.

Reset Trip Distance

• Enter “General Settings” by pressing UP [ + ] and DOWN [ - ] button at same time for over 2 seconds.

• “Trip Distance” [ TC ] will appear in lower left of screen.

• Setting the parameters can be Y / N.

• Press UP [ + ] or DOWN [ - ] to select Y / N, Y = trip distance will be reset. N = trip distance not reset.

•

To confirm and exit, press MODE [ M ] for over 2 seconds.

Note: Trip distance and single riding time will be reset at the same time.

LCD Backlight

• Enter “General Settings” by pressing UP [ + ] and DOWN [ - ] button at same time for over 2 seconds.

• Short press MODE [ M ] two times, until [ bL ] appears in lower left of screen.

• The parameter 1 2 3 mean the LCD Screen backlight brightness. 1 is the darkest, 3 is the brightest.

• Change the LCD backlight brightness parameter by pressing UP [ + ] or DOWN [ - ].

• To confirm and exit, press MODE [ M ] for over 2 seconds.

Note: The default LCD brightness value is level 1.

To Change Speed Unit between:

Miles Per Hour (MPH) & Kilometers Per Hour (KPH)

• E

nter “General Settings” by pressing UP [ + ] and DOWN [ - ] button at same time for over 2 seconds.

• Short press MODE [ M ] three times, until a small [MPH or KPH ] appears on right side of screen.

• Press UP [ + ] to switch between Kilometers Per Hour (KPH) or Miles Per Hour (MPH).

• To confirm and exit, press MODE [ M ] for over 2 seconds.