User's Manual

FCC Class B Radio Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy, and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
4. Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Notice
1. Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
2. Shielded interface cables and AC power cord, if any, must be used in order to comply with the
emission limits.
LEGAL NOTICES
3. The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modification to this equipment. It is the responsibility of the user to correct such interference.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
IC Statement
Operation is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause undesired
operation of the device.
IC Radiation Exposure Statement
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
HDMI, the HDMI logo and High-Definition Multimedia Interface are
trademarks or registered trademarks of HDMI Licensing LLC.
SPECIFICATIONS
RF Frequency: 60 GHz
Bandwidth: HRP - 1.76 GHz
LRP - 92 MHz
Max Throughput: 4 Gbps
Range: Up to 65 feet (Line of Sight)
Up to 30 feet (Non-Line of Sight)
Supported 2D Resolutions: 480i, 480p, 720p, 1080i, 1080p,
VGA, XGA, SXGA, WSXGA+
Supported 2D Refresh Rates: 23.976/24 Hz, 59.94/60 Hz
3D Video Mode Compatibility: 720p 50/59.94 Hz, 1080p 23.98/24 Hz,
Sensio, RealD
Audio Mode Support: 2-8ch LPCM, 32-192 KHz,
Dolby Digital 5.1 @ 44.1 / 48 / 96 KHz,
DTS 5.1 @ 44.1 / 48 / 96 KHz
HDMI Support: HDMI 4.1a (3D) with CEC
Power Consumption: <7W (Power On), <0.3 (Standby)
WiHD and WiHD logo are trademarks licensed for use by WirelessHD,
LLC.