User's Manual

............................................................................................................................................................................................................................................................
WAN PT M ConnectionsNetwork
5-10
3EQ-10280-AAAA-TCZZA
Edition 01 February 2011
............................................................................................................................................................................................................................................................
Port based binding
Port based mode enables you to bind ports to your WAN connection. You can bind LAN
ports 1 to 4 and WLAN SSID 1 to 4 in the WAN mode you selected. The default WLAN
SSID number is 1 and you can configure 2 to 4 in the WiFi Settings.
You can select the Port Based radio button for each WAN mode and then click Add to
proceed to the next configuration window.
In Port based mode, you can add up to four connections in routed mode.
Note: If you do not set a VLAN ID in the connections, you can only have one
connection in Static IP or DHCP mode and three connections maximum in PPPoE.
Note: If you already have a connection with Port based binding, you can not select
MAC based binding for any other connections.
The following WAN modes support port-based binding:
• Static IP
• DHCP
• PPPoE
• Bridge
Static IP
If you select Static IP as the mode in the WAN PTM Connections, the Static IP settings
window with Port based binding opens; see Figure 5-6.
Binding (read-only) Shows which ports or MAC addresses are bound on
the connection.
Delete All Click to delete all the connections.
Edit Click to modify the settings of the connection.
After changing the connection settings, press
Activate WAN Settings to activate the connection.
This button will be only visible if you made changes
to the settings or added a new connection.
Delete Click to delete the connection.
Field Description