User's Manual
Table Of Contents
Hardware installationTo install the CellPipe 7130 RG
............................................................................................................................................................................................................................................................
3EQ-10280-AAAA-TCZZA
Edition 01 February 2011
2-3
............................................................................................................................................................................................................................................................
Figure 2-1 Cable connections of 6Vz.A2131
Figure 2-2 Cable connections of 6Ve.B2131
Procedure
1. Connect one end of the gray RJ-11 cable (omly for 6Vz.A2131) or gray TAE-RJ45
cable (only for 6Ve.B2131) into the gray DSL port on the CellPipe 7130 RG and the
other end to your telephone/VDSL service connection.
2. Connect one end of the yellow RJ-45 Ethernet cable to any of the yellow Ethernet
LAN ports (1 to 4) on the CellPipe 7130 RG. Connect the other end of the cable to
your Ethernet PC (or LAN hub if you are setting up an intranet).
3. Turn the power switch on.
........................................................................................................................................................
E ND OF STEPS
You might need to configure the Internet properties on your Ethernet PC; see Appendix B,
TCP/IP configuration, or the Quick Installation Guide for detailed instructions.
After setting up the CellPipe 7130 RG and your PC(s), you can access the web
configuration tool; see Accessing the CellPipe 7130 RG web configuration tool.