User's Manual
Table Of Contents
............................................................................................................................................................................................................................................................
To install the CellPipe 7130 RGHardware installation
2-2
3EQ-10280-AAAA-TCZZA
Edition 01 February 2011
............................................................................................................................................................................................................................................................
Important! Make sure that the screws are securely fixed to the wall and strong
enough to hold the weight of the CellPipe 7130 RG (recommended screw type and
size: Nylon wall plug [T8x25mm] and screws [T3.5x16mm]).
2. Align the holes on the back of the CellPipe 7130 RG with the screws on the wall and
then hang the CellPipe 7130 RG on the screws.
........................................................................................................................................................
E ND OF STEPS
Desktop mounting
Place the CellPipe 7130 RG with the rubber feet at the bottom on a flat and stable surface.
Stand-up mounting
Snap the cradle into the holes located on the side of the CellPipe 7130 RG and then place
it on a desk so that LEDs are visible.
To install the CellPipe 7130 RG
Supplies
•
CellPipe 7130 RG
• One RJ-11 telephone cable (only for 6Vz.A2131)
• One TAE-F to RJ45 cable (only for 6Ve.B2131)
• One RJ-45 category 5 Ethernet cable (yellow)
• Power adapter
Before you begin
CAUTION
Potential for equipment damage and personal harm
Before installing the CellPipe 7130 RG, ensure you have thoroughly read the Safety
precautions and Prerequisites in chapter 1.
Turn off all devices (computer, hub, CellPipe 7130 RG) before beginning this procedure.