User's Manual

QoS PTM setupQoS Phone
............................................................................................................................................................................................................................................................
3EQ-10280-AAAA-TCZZA
Edition 01 February 2011
9-7
............................................................................................................................................................................................................................................................
QoS Phone
The QoS Phone window enables you to configure DSCP value and CoS value of SIP and
RTP Sessions.
Select
QoS Phone in the QoS PTM Setup menu to access the QoS Phone window; see
Figure 9-4.
Source IP IP address of the source host.
Netmask Subnet mask of the source IP address.
Source Port Port number of the source host.
Destination IP IP address of the destination host.
Netmask Subnet mask of the destination IP address.
Destination Port Port number of the destination host.
Protocol The protocol type for this QoS policy.
Priority The priority queue (0 to 7) used by the traffic.
CoS CoS value of the QoS policy.
ToS/DSCP ToS/DSCP marking setting for incoming traffic.
Change Precedence Select a QoS rule precedence number and then select
where to move it:
• Up: move this QoS rule to higher priority.
• Down: move this QoS rule to lower priority.
• Delete: remove this QoS rule.
Click Apply to change the precedence.
Field Description