User Manual Part 1

LaCie Wireless Space • DESIGN BY NEIL POULTON Introduction
User Manual page 14
1.9. Default Settings
IMPORTANT INFO: DO NOT attempt to access the Wireless
Space via the web-enabled Dashboard (see 3.6.1. Dashboard: Ac-
cessing) before running the Setup Wizard. During the initial con-
figuration, the Setup Wizard must find the Wireless Space on the
network. If the Dashboard has made contact with the device, the
Setup Wizard will not run since it believes the choice of configuration
has already been made. This could be problematic when attaching
the Wireless Space to a network with a router, server, or Internet
provider that assigns IP addresses using DHCP. Most DHCP serv-
ers or devices use the same default settings as the Wireless Space
when it is set to a Router configuration, which can create IP address
conflicts on a network.
The Wireless Space is shipped with the following default settings:
Setting Default
Host/Server name WirelessSpace
Domain name local
Workgroup WORKGROUP
IP Mode for WAN Interface DHCP
LAN Interface IP address (Router
configurations only; see 4.1. Be-
fore the Installation)
192.168.1.1/24*
Internet port IP address (Switch
configurations only; see 3.7. IN-
TERNET Port: NAS+Switch)
172.20.0.1
Time zone Greenwich Mean Time
(GMT) + 1
Configuration NAS+Router - Wired Only**
Light Blue when powering on,
followed by green since the
Wi-Fi has been disabled
Login admin
Password admin
*The number “24” following the slash represents the bits used to find
a subnetwork. In most cases, this is not important to the standard
user.
**Using the Wireless Space as a router may be suitable for many
users but LaCie highly recommends running the Setup Wizard since
there are additional settings to consider.