User's Manual

Copyright © 2017 Gemtek Technology Corporation. All Rights Reserved.
6
QW_02_0035.001
Figure 7 - Node Parameters
User can input a device address in the blank field and click “APPLY” to filter,
click “CLEAR” to cancel filter.
Click “REFRESH”to renew Node Parameter information.
When there are over 20 Node Parameters entries on the page, users can click
on the page number on the upper-right corner to move on to the next page.
Definition of Node Parameters Fields:
DevAddr: The unique device address of node.
Rx1DrOffset: The downlink data rate offset of Rx1.
Rx2DataRate: The downlink data rate of Rx2.
Delay: The delay between TX and RX.
Rx2Freq: The downlink frequency of RX2.
LastDownMsgSeqNo: The number of downlink data sent.
3.3 LoRaWan - OTAA
The purpose of this category is to view and configure OTAA rules.
Click “ADD” button to enter OTAA add page and input Group Index, AppEUI Start,
AppEUI Counts , DevEUI Start , DevEUI Counts , Devaddr Start, Devaddr Counts,
Appkey and Aging Out Time, then click “SAVE” to create an OTAA rule.
User will leave OTAA add page after clicking “CANCEL”.
Following information on the OTAA:
Group Index: The unique index of OTAA EUID group.
AppEUI Start: The start number of AppEUI.
App Counts: The number of AppEUI in this Group.
DevEUI Start: The start number of DevEUI.
DevEUI Counts: The number of DevEUI in this Group.
DevAddr Start: The start number of DevAddr.