User's Manual

4 Installation
4 Installation
Before installing the ODU, verify that you have all the items listed in section 1:
What You Need. If any of the items are missing or damaged, contact your LTE
service provider.
Step 1: Selecting a Location
The ODU should be pole-mounted outdoors and aligned so its antenna faces the
nearest LTE base station. When selecting a suitable location for the unit, consider
these guidelines:
1. Place the ODU as high as possible to achieve the best possible link quality.
2. Place the ODU away from power and telephone lines.
3. Avoid placing the ODU too close to any metallic reflective surfaces.
4. Be sure to ground the ODU with an appropriate grounding wire (not included)
by attaching it to the grounding screw on the unit and to a good ground
connection.
Step 2: Before Mounting the Device
1. Make sure the ODU is turned off and NO PoE supply connected before you
insert SIM card or it may damage your SIM card.
2. Please Check below items before installing the outdoor device
 LED indicator inside and SIM card slot for inserting SIM card
 One RJ-45 connector for connecting to the ODU to IDU or PoE
Supplier
 Make sure the grounding screw on the rear panel
Step 3: Connect the cable with waterproof node
1. Remove the sealing gland plug from the gland nut.
2. Open the sealing gland nut and remove it. Do not disassemble the gland base
from the bracket.
3. Insert the cable into the sealing gland base and connect it to the RJ-45
connector at the bottom of the ODU, labeled. Make sure that the connector is