User's Manual

2. Connect the cable

• Remove the sealing cable gland plug from the gland nut.

• Open the sealing gland nut and remove it. Don not

disassembles the gland base from the bracket.

• Insert the cable into the sealing gland base and connect it to

the RJ-45 connector at the bottom of the CPE. Make sure the

connector is completely inserted and tightened.

• Insert the rubber bushing on the cable into the gland base.

• Tighten the gland nut. Use the dedicated tool for fastening

the sealing glands.

3. Seal the connector

• Attach the mastic tape (Scotchfil

Electrical Insulation Putty)

and wrap it around the connector butting up against the

connector. Do not over stretch.

• Squeeze to tighten the mastic sealer. Make sure there are no